Bug Reports for CFDEM®coupling, LIGGGHTS®, and ParScale

(Possible) bugs / suspicious behavior should be reported as a new thread here, not in the user forum. This should give both you and the developers a clear idea about the status of your bug report (submitted/assigned/fixed)

[BUG#3-fixed-LIGGGHTS] COORDINATION NUMBER CALCULATION

Submitted by ckloss on

Bug description:
Coordination number is not calculated correctly by compute coord/gran

Applies to:
LIGGGHTS 1.4.1 and older

Comments:
Was due to a faulty neighbor list request

Reported by:
Mark Bentley (Space Research Institute, Austrian Academy of Science) and user prasantud

Status :
(31 August 2011): Tracked back and fixed the bug, will be part of release 1.4.2
(8 Sept 2011): Fix released in 1.4.2

[BUG#2-fixed-LIGGGHTS] DUMP STL WRITES MULTIPLE FOOTERS IN PARALLEL

Submitted by ckloss on

Bug description:
dump stl command writes out more than one "ENDSOLID" line to the STL file

Applies to:
LIGGGHTS 1.4.1 and older

Comments:
Applies in parallel, does not affect display-ability of files in paraview

Reported by:
Timo Kulju, Oulu University Finland

Status :
(31 August 2011): Tracked back and fixed the bug, will be part of release 1.4.2
(8 Sept 2011): Fix released in 1.4.2

[belongs to bug #3]Co-ordination number problem

Submitted by msbentley on

This probably relates to this problem, but I've posted a new topic to attach some images...

I have just tried to verify the coordination number for some simple packings (in this case simple cubic). I have computed and dumped the coordination number using computer coord/gran. I was expecting a coordination number of 6 everywhere apart from at the edges...

[belongs to bug #2] dump stl bug?

Submitted by tkulju on

Hi!
I've noticed a strange behavior in dump stl command. For example the line

dump dumpstl all stl 10000 post/dump*.stl

writes two endsolid-lines in the end of the every written .stl file. I have a rotating geometry, where I have static and rotational part, which both have their own stl-files. For post-processing this is not a problem, but for restarting purposeses it's a bit annoying.

[BUG#1-remedy_available-LIGGGHTS] PARTICLES FALL THROUGH STL WALL

Submitted by ckloss on

Bug description:
Particles falling through STL walls - though they should not

Applies to:
Reported for LIGGGHTS 1.2.9, 1.3.3, 1.4.1 only if compiled with icpc 12

Comments:
Compiler related: Occurs with Intel compiler icpc, version 12, works fine with version 11 and older.
After talking to a number of experts, the conclusion is that this is a compiler bug.

Remedy:
Compile with "-fstrict-aliasing" if using Intel icpc 12

Reported by:

[belongs to bug #1] wall/gran/.... style mesh/gran

Submitted by r.jabakhanji on

Hi guys,

I hope you are well.

The wall style mesh/gran for wall/gran/... seems to be transparent to particles. i tried modifying skin size, time step, young's modulus, nothing is working. The particles go through the mesh as if it were not there!

I checked it on the example "chute_wear" same behavior!

Any ideas? I am stuck :(

Rami.