spheres overlap during the generation of a packed bed of spheres

Submitted by salvo on
JoshuaP

hey,

insert them with smaller diameter and than grow them slowly to the true diameter.
Here is an example:

#parameters for gradually growing particle diameter
variable growts equal 50000
variable growevery equal 40
variable relaxts equal 100000
#region and insertion
group nve_group region reg
#particle insertion
fix ins nve_group insert/pack seed 5330 distributiontemplate pdd1 &
maxattempt 200 insert_every once overlapcheck yes all_in yes vel constant 0. 0. 0. &
region insreg mass_in_region ${totalmass}
#apply nve integration to all particles that are inserted as single particles
fix integr nve_group nve/sphere
#output settings, include total thermal energy
compute radi all property/atom radius
compute minradi all reduce min c_radi
compute maxradi all reduce max c_radi
compute maxz all reduce max z
variable Rgrowrate equal ${scalereduction}^(${growevery}/(${growts}))#ramp(2.1,0.2)
compute 1 all erotate/sphere
thermo_style custom step atoms ke vol dt etotal c_minradi c_maxradi v_Rgrowrate c_maxz
thermo 1000
thermo_modify lost ignore norm no
compute_modify thermo_temp dynamic yes
#insert the first particles
run 1
dump dmp all custom 10000 post/dump.fill id type type x y z ix iy iz vx vy vz fx fy fz omegax omegay omegaz radius
unfix ins
print "The radius grow rate is Rgrowrate"
#do the diameter grow
compute rad all property/atom radius
variable dgrown atom ${Rgrowrate}*2.*c_rad #mal 2 wegen von Radius auf Durchmesser
fix grow all adapt ${growevery} atom diameter v_dgrown
variable deltatime equal sqrt(${rho}/($E/(2*(1+$v))))*c_minradi*PI/(0.1631*$v+0.876605)/5
timestep ${deltatime}
variable neigh equal c_maxradi*2
neighbor ${neigh} bin
#run
run ${growts}
variable deltatime equal sqrt(${rho}/($E/(2*(1+$v))))*c_minradi*PI/(0.1631*$v+0.876605)/5
timestep ${deltatime}
variable neigh equal c_maxradi*2
neighbor ${neigh} bin

Fri, 10 Jul 2015 - 13:01 Permalink

Hello Everybody,

My study is dedicated to create packed bed of spheres and run simulation CFD to investigate the mass and heat transfer in the packed bed reactor. The problem I found when I create a packed bed of spheres with the script "in.packing" is that some spheres do not each other well and in some spheres there is a overlapping. This problem will affect the generation of the mesh. My question is if I can avoid this problem creating a packed bed without overlapping so just with normal contact points between the spheres and the wall ?

If you want I can upload the script I use to generate the packed bed!

Thank you in advance for your interest,

best regards
Sickert