Hi Guys!
I´m trying to configure a simple test case. I took movingMeshGran as a start point for my angle of repose test, but I find that the inserted particles pass through the solid "bucket.stl". Post-proccesing the result I find that the bucket "became" a solid at 150 paraview timestep.
http://imageshack.us/a/img10/5841/screenshot3zl.png
How can I configure this "bucket" to be a solid all the time?. I need this to configure my case and fill the cylinder ( 2 equal sides, 2 stl files) with nparticles, and then move the walls.
Saludos!
Andrés
ckloss | Wed, 10/24/2012 - 23:58
Hi Andrés, the mesh becomes
Hi Andrés,
the mesh becomes "solid" when the fix wall/gran command is issued that uses the mesh, before that, there is no interaction with the particles whatsoever
Christoph
greel | Thu, 10/25/2012 - 20:16
how to
Hi Christoph, thanks for your answer.
I still trying to configurate my case but the particles are passing througth my walls ( side1.stl ) and They interact with particles only after move/mesh is activated.
Is there any way to use the same wall to contain the particles until the filling process is completed the and then move/mesh the walls??
To test this I´m trying to make that bucket.stl from in.movingMeshGran interact with the particles during all simulation time, but also the same "problem"
Saludos!
pd: sorry about my english!
ckloss | Mon, 10/29/2012 - 14:51
Hi Andrés, I would suggest to
Hi Andrés,
I would suggest to debug your simulation step by step. You can also start from the meshGran example (where the mesh is active from the beginning on) and add a moving mesh lateron
Cheers, Christoph