Wear prediction - follow up

Hi Everyone

(I wanted to post the information below (and some more pictures) as part of the original "Wear prediction" topic, but the option to attach files was not further available. That is the reason I start this topic as a follow-up. Is there a better way?)

Further to the previous postings on this topic:

I dont think the problem is in Paraview. I did the following:
* I ran the chute_wear input file (in.chute_wear) on v1.2.1-beta and on v1.2.2-beta
* I used the output file "dump99800.vtk" from both above versions of LIGGGHTS to make attached image files that:
~ show centers of triangles (calculated from the POINTS and POLYGON data in above dump files);
~ centers are colour-coded red if the wear is zero, and green if non-zero

From the above mentioned images one sees that, again, wear is only predicted for the bottom-left corner of the model. I expected that wear be predicted in more or less a mirror image accross the horizontal centerline of the model, i.e. top left of model should be mirror of bottom left?

Referring to attached files it appears the same problem exist as previously reported.

Could somebody (Chris?) please send me "dump99800.vtk" from you simulation if you think yours works fine? I assume that the original input file is used unchanged in all cases.

Kind regards

Alexander