Hi everyone,
I've been using and reading the heat/gran documentation and have a few comments...
1) In the writing (and I think an example case that comes with LIGGGHTS 2.x?) it says that the keyword is property/atom but then the example has :
set region srcreg property/peratom heatSource 0.5
I tried running this property/peratom and received errors. In some cases I do believe the property/atom did work. I just want to point out that I think there's a mismatch between the code and the documentation.
but
2) I also tried running this set command after a restart and I see the echo print of "0 settings made for property/atom" in my terminal. The command I give is:
set region bc property/atom heatSource v_nucheat
I've used just constant values in place of the v_nucheat and still I get 0 settings made for property/atom. Has anyone else had an issue with the set command not working with restart data?
Regards,
Jon
jtvanlew | Tue, 03/05/2013 - 23:11
Ok so my problem of getting
Ok so my problem of getting "0 settings made for property/atom" was my fault. I was referencing a region that all the particles had already moved out from. However, I am having the separate problem of, when choosing the right region, I get the notification that it is "Setting atom values ..." but then the program hangs up there. I left it on all night and in the morning the values hadn't been set.
I haven't had problems doing this until I tried applying the heat to restart data...
jtvanlew | Wed, 03/13/2013 - 22:28
OK this problem can be closed
OK this problem can be closed. There was no bug or error with loading restart data. All that needed to be done was do a single "run 1" before making the set heatSource command.
I thought I'd done that before and still had the error -- but who knows. I must have had multiply layers of problems hiding this simple solution.