Questions about Chute Example

Submitted by huangdf on Thu, 12/27/2018 - 08:26

I am new to use CFDEM Workbench and trying to follow the Chute Example.

I was stocked at "DEM Setup" -> "General Settings". In the tutorial doc there is "boundary" settings. However, on my "General Settings" no boundary settings were found.

If anyone here know what is the problem.



alice's picture

alice | Wed, 01/16/2019 - 15:27

Hello Dawn,

you are right, the boundary settings have been moved to another section (expert settings). If you move to this tab, you will find them there! They still wor in the same way.