mesh/gran offset

Submitted by dnojiri on Wed, 02/29/2012 - 13:44

Hi

Im able to run the simulation and in paraview observe the mesh created through stl file.
Also I changed the scalefactor from 1 and 0.1 and was able to appreciate the difference in size of the mesh.

My problem is the offset. I tried to move the mesh by changing the xoff, yoff and zoff, but nothing happens. The mesh always stays in the same place.

Have someone had the same kind of problem?

Forums:

ckloss's picture

ckloss | Wed, 02/29/2012 - 16:14

>>The mesh always stays in the same place.
Please note that you have to provide the _unscaled_ offset (see doc for details). I know this is probably not the best implementation (will be changed in the next major release)

Cheers, Christoph