insertion particles when using parallel process

Submitted by g.garate on
Attachment Size
serie vs paralelo.jpg 75.48 KB
ckloss

I am not sure if I completely understand what the pic shows, but yes, there is a difference in in

As insertion in LIGGGHTS is parallelized and communication between processes is avoided, there is some unavoidable "gap" on the inter-processor boundaries

Best
Christoph

Tue, 14 May 2013 - 12:50 Permalink
g.garate

The pic shows the "gap" on the inter-processor boundaries. Is there any line I could to add or modify in the input script in order to avoid this gap?

Regards

Tue, 14 May 2013 - 18:24 Permalink
ckloss

Hi,

>>Is there any line I could to add or modify in the input script in order to avoid this gap?
no - this is unavoidable. But typically it's not a problem. You could use alternative ways of insertion (e.g. via data file) is this is critical for your application

Christoph

Tue, 14 May 2013 - 23:34 Permalink

Please take a look at the attached file, it is a picture with two images. The one of the left side is a simulation using series process. The one of the right side is a simulation using parallel process (processors 2 2 1). As you can see, the last one has a lack of particles due to the division of processors. Is it normal this situation?

Regards