I am about to start working both with cohesive materials, and also with heat flow - in both of these cases the contact area between particles is an important parameter. It would be great if this value could be exposed to compute pair/gran/local so that it could also be output via dump local...
I can probably figure out the changes if nobody else finds it useful, but I haven't yet started to dig into the code base ;-)
Thanks! Mark
ckloss_ | Sun, 08/21/2011 - 22:24
Yes, good idea. I will put in
Yes, good idea. I will put in on my list :-)
Cheers, Christoph
msbentley | Tue, 08/23/2011 - 13:52
.. and per contact heat flow would also be useful ;-)
Great! It would also be useful to expose per-contact thermal information (e.g. per contact heat flow), to truly visualise the heat flow network etc. :)
ckloss_ | Wed, 08/24/2011 - 00:40
you're right... added to the
you're right... added to the list too :-)