Hi Everyone
I am running a model of a drum with spheres in it. The drum is imported from an STL file. When I run this, I get the following warning repeatedly:
"WARNING: Dangerous build in triangle neighbor list."
Do I need to be concerned with this? Is there perhaps a problem with the STL file? I did notice that my spheres might be escaping the drum, but I need to double-check for a reason.
I could only find the following in the "fix_tri_neighlist.cpp" file:
//if a fix move/mesh/gran is registered, advise the user to increase skin safety (and eventually shorten time-step)
//if a fix pour is registered, advise the user to increase distance between insertion region and the mesh/gran wall
I think none of the above advice is applicable since I am not using the mentioned fixes in the model.
Thank you
Alexander
Re: Dangerous build in triangle neighbor list
Hi Alex,
that is most probably a bug - I recently discovered a bug in that routine that will be fixed in the next release - probably it is related to that.
If you mail me the input script and the STL file I will have a look.
Best,
Christoph
In reply to by anonymous_stub (not verified)
Re: Re: Dangerous build in triangle neighbor list
Hi Alex,
some of your particles that you read into the simulation from the data file have an inital overlap with the wall - which is bad!
You should generate them in a way that they have a safe distance from the wall when they are read.
Please see if the error persists then (it hopefully shouldn't)
Christoph
In reply to by anonymous_stub (not verified)
Hi Christoph, What do you
Hi Christoph,
What do you mean by safe distance from the wall? Should it be large or small gap?
Best..
Ram
In reply to by anonymous_stub (not verified)
Re: Gap distance
Hi ram,
there should be no initial overlap with the wall. In earlier versions you had to obey a certain distance from the wall to the insertion volume, but in 1.0.4, this is no longer necessary.
You only have to be careful when using fix pour/legacy because it generates the particles in a way that only the particle centers are in the insertion region, whereas the new fix pour/dev generates the particles in a way that they are completely contained within the insertion region
Christoph