does mesh/surface/stress/servo take the fluid pressure into consideration

Submitted by coffeeorme123 on
alice

Hello,
so far the servo wall only reacts to the forces they are exerted in the DEM calculation. The "general" force that is induced by the flow is unknown to the DEM calculation and thus also to the servo wall.
Cheers,
Alice

Tue, 18 Feb 2014 - 15:57 Permalink

Hi, everybody,
I am trying to use the mesh/surface/stress/servo command of liggghts to realize a constant-stress wall in a CFDEM case. I know that when establishing case using liggghts solely,the servo wall works fine. But if I want to use this command in a two-phase system including fluid and particles, does it consider the pressure which is induced by the fluid phase when adjusting the stress? Could anyone help me?~~

Thanks !