Forums
Hi all, I set the units system to be si in the beginning.
Later I used fix mesh/surface/stress and export the pressure/shear/stress by dump mesh/vtk.
what's the unit of the output??? the pressure, shear, stress components??
N? Pa? kPa??
I am not sure.
thanks for help
Regards,
Xiuhan
unit of fix mesh/surface/stress
Hi Xiuhan,
if you are using SI units, I suppose the corresponding unit for pressure is Newton per square metre.
1 N/m^2 equals 1 Pascal
Best regards,
MiRa
In reply to by anonymous_stub (not verified)
Hi MiRa, are you sure? I have
Hi MiRa, are you sure? I have checked the manual. In the page of ¨fix mesh/surface/stress command¨. It is stated:
¨This fix is identical to fix mesh/surface except for the fact that the pressure and shear force that the particles in
the fix group exert on each triangle of the mesh is evaluated (which costs a bit of performance). Also, the total
force and torque on the particle is calculated (see output info). The per-element forces can be dumped into
VTK format using dump mesh/vtk.¨
and
¨This fix stores a global vector with 6 components for access by various output commands. The first 3
components are equal to the total force on the mesh, the last 3 components store the total torque on the body
exerted by the particles. Other info see fix mesh.¨
You see here they mentioned ¨force¨.
On the contrary, in the manual ¨dump command¨, it is stated:
¨The mesh/vtk style can be used to dump active mesh geometries defined via fix mesh commands to a series of
VTK files. Different keywords can be used to dump the per-triangle stress, id, velocity, wear, stress
components, area or the process which owns the element (visulatisation of the parallel decomposition) into the
specified file using a VTK file format.¨
You see here it is mentioned as ¨stress¨
I am deeply confused about this. Hope the developers can give an official definition.
regards,
xiuhan
unit of fix mesh/surface/stress
Hi Xiuhan,
"This fix is identical to fix mesh/surface except for the fact that the pressure and shear force that the particles in
the fix group exert on each triangle of the mesh is evaluated".
Seems to me like one would receive a list of stresses for each surface triangle; given in the corresponding stress unit
"Also, the total force and torque on the particle is calculated".
These results would then be output for the mesh as a whole; in force or torque units, repectively.
So, depending on which column of your dump file you are looking at, you either see mechanical stress or force/torque.
This is how far my understanding goes and I hope that it helps you. I would also appreciate if one of the developers could clarify.
Best regards,
MiRa
Hi all,
Hi all,
if you using SI units, the output is in SI as well (same of course for cgs)
>>So, depending on which column of your dump file you are looking at, you either see mechanical stress or force/torque.
Correct!
Best wishes
Christoph