Forums
Hello all,
I need to put particles on a curved surface. In OpenFoam I can do that easily using blockMesh, but for DEM part, how can I create the wavy region to insert particles?
I used gmsh to create the curved surface with the same coordinate i used in blockMesh and saved them as .stl file to read by DEM.
When i run the file it shows the following error:
ERROR: Fix insert/stream (id ins): command requires a planar face for insertion (fix_insert_stream.cpp:230)
How can i insert partcle in a curved/wavy surface.
Any suggestion will be appreciated.
Thanks
Manjura
Do you wish to have the
Do you wish to have the particles sitting atop the wavy surface? Is it just a single layer of particles or many layers that are upon the curved surface?
You might be better served with the fix insert/pack for which you specify a region above the wavy surface to allow the particles to fall upon it.
Yes. I should have multiple
Yes. I should have multiple layers of particles on wavy surface. For insert/pack, how could i create a region above the wavy surface?
Have any idea?
Thanks
Manjura
i'm not sure if you need the
i'm not sure if you need the insertion volume to trace the wavy surface, but if you can do a simple block it'd just be something like...
define the region:
region bc block -0.1 0.1 -0.1 0.1 0. 1. units box
where there's a cube with xmin, xmax, ymin, ymax, zmin, zmax dimensions.
then some code for defining your particles...
fix pts1 all particletemplate/sphere 1 atom_type 1 density constant 3600 radius constant 0.01
fix pdd1 all particledistribution/discrete 54651 1 pts1 1.0
and then finally the insertion command:
fix ins all insert/pack seed 100001 distributiontemplate pdd1 vel constant 0. 0. -0.1 insert_every 10000 overlapcheck yes all_in yes particles_in_region 1000 region bc
this might not be exactly what you're looking for but I hope it sends you in the right direction.
Yes, I did that part of
Yes, I did that part of simple block. But now I have to insert particles in a wavy bottom region. Though i create wavy surface , but I didn't find a way to create that wavy region.
Thanks for your ideas anyway.
Hi manjura,
Hi manjura,
you can use the region mesh/tet command
Cheers
Christoph
Hello,
Hello,
Thanks for your suggestion.
I created a wavy region with gmsh as .vtk file to compatible with the 'region mesh/tet command'....but it still shows the following error now-
WARNING: VTK file contains other types than tetrahedra - only tets are currently supported in LIGGGHTS, other cells are discarded (input_mesh_tet.cpp:276)
ERROR on proc 0: This feature is not available for tet mesh regions (region_mesh_tet.cpp:141)
Any help?
Thanks
Manjura
I guess you are using "all_in
I guess you are using "all_in yes"? This is not available for tet meshes at this point
Christoph