Creating animations in Paraview

Submitted by RocheDEM on
Attachment Size
m13.0068.jpg 87.54 KB
m13.0069.jpg 19.25 KB
Somnath

Yeah, I had the same problem recently. I figured that my RAM and/or Swap memory was getting full as the animation progressed and Paraview stopped saving the .jpg's with the glyph once the total memory was full. I increased my swap to deal with it.

cheers
Som

Tue, 16 Oct 2012 - 20:04 Permalink
RocheDEM

In reply to by anonymous_stub (not verified)

Thanks all for the help. I ended up going with the pointsprite, it seems to be the best way to go.

Kirk

Thu, 18 Oct 2012 - 13:47 Permalink
msbentley

In reply to by anonymous_stub (not verified)

There was, if I remember correctly, also a ParaView bug that caused a memory leak during saving of animations - but it could be worked around by toggling parallel projection - I forget whether on or off, but it's worth toggling and trying again!

Cheers. Mark

Thu, 18 Oct 2012 - 11:47 Permalink
DanielDroop

Hi Kirk,
search this site for how to activate the point sprite plugin for paraview. It's mentioned in the howto_paraview.pdf in the download section. Using the point sprite representation is much faster (and memory efficient?) than using glyphs.

Good luck,
Daniel

Wed, 17 Oct 2012 - 20:58 Permalink

Hi,

I am having trouble getting my animation to save correctly. I have made animations in Paraview before, but this is the first time that I get this problem.

When I go to File-Save Animation, I select the frame rate etc. The sequence of .jpg's starts, but after 70 or so files are created, the files no longer show the model, just a blank paraview screenport without any results.

The problem only seems to occur when I render the particles as spherical glyphs. When I save the animation just with the points (not very esthetically pleasing) all the .jpg's get created correctly.

Has anyone run into this problem before, can someone help me get this working.

I have attached a sample jpg just before and just after the problem.

Thank you

Kirk