From CFD side the solver is incompressible and thus the whole momentum balance is divided by rho. Thus you end up with a kinematic viscosity instead of dynamic and a modified pressure (check the units of p field).
So there is actually no direct density in the flow solver.
Further an higher fluid density would result in a buoyancy force of the particles. There were already some posts on how to implement buoyancy.
Finally, I figured out the seemingly correct way to simulate particle settling in water:
Times drag and Buoyancy by 1000 (to make sure correct force is used in DEM)
and divide Ksl by 1000 (to make sure correct momentum is transfered to continuous phase)
The results so far looks right. I will try to upload my file if necessary.
Hi! From CFD side the solver
Hi!
From CFD side the solver is incompressible and thus the whole momentum balance is divided by rho. Thus you end up with a kinematic viscosity instead of dynamic and a modified pressure (check the units of p field).
So there is actually no direct density in the flow solver.
Further an higher fluid density would result in a buoyancy force of the particles. There were already some posts on how to implement buoyancy.
Cheers,
Chris
In reply to by anonymous_stub (not verified)
Hi Chris, Thanks for your
Hi Chris,
Thanks for your comment.
Finally, I figured out the seemingly correct way to simulate particle settling in water:
Times drag and Buoyancy by 1000 (to make sure correct force is used in DEM)
and divide Ksl by 1000 (to make sure correct momentum is transfered to continuous phase)
The results so far looks right. I will try to upload my file if necessary.
Thanks.
rq