Submitted by ZYan on Wed, 19 Feb 2014 - 10:34 Forums LIGGGHTS® - User Forum aaigner More information? Hi Zilin, without more information it is quite difficult to help you: Did your simulation stop at the start? Is your simulation box big enough? Did you use a mesh mover or a servo wall? Did you move your mesh out of the box? Cheers, Andreas Log in or register to post comments Thu, 20 Feb 2014 - 17:54 Permalink ZYan In reply to More information? by aaigner Thanks Andreas, Thanks Andreas, Yes. The mesh was moved out of the box because i chose too big timestep. Cheers, Zilin Log in or register to post comments Mon, 24 Feb 2014 - 16:11 Permalink Log in or register to post comments Dear Colleagues, My simulation ended up with an erro: Mesh elements have been lost (multi_node_mesh_parallel_I.h:613) Does some one know what might be the reason? Thank you Cheers, zilin
aaigner More information? Hi Zilin, without more information it is quite difficult to help you: Did your simulation stop at the start? Is your simulation box big enough? Did you use a mesh mover or a servo wall? Did you move your mesh out of the box? Cheers, Andreas Log in or register to post comments Thu, 20 Feb 2014 - 17:54 Permalink
ZYan In reply to More information? by aaigner Thanks Andreas, Thanks Andreas, Yes. The mesh was moved out of the box because i chose too big timestep. Cheers, Zilin Log in or register to post comments Mon, 24 Feb 2014 - 16:11 Permalink
More information?
Hi Zilin,
without more information it is quite difficult to help you:
Cheers,
Andreas
In reply to More information? by aaigner
Thanks Andreas,
Thanks Andreas,
Yes. The mesh was moved out of the box because i chose too big timestep.
Cheers,
Zilin