Pseudo 2D-CFD simulation coupled to DEM - Particle vs Mesh size

Submitted by AndresMM on

An important aspect when using cfdemSolverPiso is that the particles must be smaller than the mesh cells in OpenFOAM.

In OpenFOAM one often does a pseudo-2D simulation where there is only one cell in Z-direction.

How correct would it be to make a pseudo-2D simulation in openFOAM and couple it to LIGGGHTS where the particle diameter are near the cell size in X and Y direction, and just increase the Z-dimension of the CFD-mesh? The LIGGGHTS simulation only has a "sheet" of particles which remain on their Z-position (very dilute, almost no collisions), so one can pretty much set the voidFraction by increasing the Z-dimension.

Cheers,
-A