Particles ignoring servo wall in CFDEM

Submitted by livioys on
Attachment Size
pic.png 53.45 KB
compression.tar_.gz 217.35 KB
j-kerbl

Hi Livio,
the servo-wall should run just as good in CFDEM as in pure DEM.
Are you using the same liggghts file for pure DEM and CFDEM?

If you still experience the problem, could you upload your CFDEM case as a tar.gz or something similar?

Cheers
Josef

Thu, 17 Mar 2016 - 16:17 Permalink
livioys

Hi Josef,
Not the same file, but similar code. I just uploaded the case.
Thank you

Sat, 19 Mar 2016 - 22:44 Permalink
livioys

I got it working now. The problem was that I was not using the servo wall command after restarting the simulation

Tue, 29 Mar 2016 - 23:30 Permalink

Hi, everyone

I am having this problem with the servo wall, the particles are crossing the wall like if it was not there. I attached a picture to illustrate the problem, and also the log file. I basically modified the example on cfdemSolverPisoScalar with a smaller box and particles, and fluid flow in the x-direction.

The code works on LIGGGHTS but I don't know if I need any specific modification for CFDEM.
I really appreciate any help you can provide,
Livio