Hi, for school I am working on a liggghts project. I have drawn my geometry and want to use it in my liggghts simulation. I have already done this before without any problems, however, now whatever I try I get the following error message:
ERROR on proc 1: Fix mesh: Bad mesh, cannot continue. You can try setting 'curvature' to 1e-5 or lower or use 'curvature_tolerant yes' (../surface_mesh_I.h:648)
I have tried to change my mesh many times but nothing helps. Now I would like to turn off the curvature_tolerant which can be seen in the error message and also on the link below. However, I cannot find where to make this adjustment. Can someone tell me where to look or what command to use?
Thanks in advance,